Shower / Tub Accessories

• Square shaped towel bar
• Fabricated from triple chrome plated rust-resistant Zamak
• 3/4″ (19 mm) square steel tubing
• 21 gauge (.032 in. <.81 mm> wall) tubing
• Triple chrome plated steel tubing
• Surface mounted
• Available in 18″ and 24″ lengths

• 0760-Z-18 – 18″ Length (457 mm)
• 0760-Z-24 – 24″ Length (610 mm)

Model / Series
0760-Z

Type
Towel Bar (Square) – Surface Mounted, Chrome Plated Zamak

Dimensions
18-36″ x 1-7/16″ x 3-3/16″ (457-914 x 37 x 81 mm)

Bar
3/4″ (19 mm) Square, 21 Gauge Steel Tubing

Construction
Chrome Plated Zamak with Triple Chrome Plated Steel Tubing

Mounting
Surface Mounted

• Triple Chrome Plated

Washroom accessory products require regular surface cleaning. As long as a regular cleaning schedule is followed, clean with a soft clean rag moistened with a mild detergent, followed by a water-moistened clean rag and then a dry rag.

For general utility, mount bar 50″ (1270 mm) Above Finished Floor (AFF) from center line of towel bar.

Locate wall brackets in appropriate positions and secure wall plates with two (2) self-threading screws (by others) through two slot holes in wall plates.

Install brackets over wall plates and fasten in place with stainless steel set screws through tapped holes in brackets.

• Product Care & Maintenance
• Technical Data Sheet – 0760-Z

• Heavy Duty - Round Shaped Rod - 1″ diameter
• Type 304 Stainless Steel - Satin Finish
• Heavy duty solid cast brass plated support posts
• Designed not to turn in support posts
• Surface Mounted

• 0755-SS-18 – 18″ Length (457 mm)
• 0755-SS-24 – 24″ Length (610 mm)

Model / Series
0755-SS

Type
Towel Bar (Heavy-Duty) – Surface Mounted, Stainless Steel

Dimensions
Available in 18″ and 24″ (457 and 610 mm) lengths.

Overall Dimensions
(variable length”) x 2-5/8″ x 2-1/2″ (variable x 67 x 64 mm)

Towel Bar
1″ (25 mm) O.D. x 20 gauge, type 304 stainless steel

Support Posts
Heavy solid cast brass plated to have stainless steel satin finish to match stainless steel

Mounting
Surface Mounted

• Satin Finish

Stainless steel washroom accessory products require regular surface cleaning. Clean with a soft clean rag moistened with a mild detergent, followed by a water-moistened clean rag and then a dry rag.

Stainless steel should be protected against muriatic acid, caustic or abrasive materials, and harsh cleaning detergents.

Surface mount each support post to wall with three (3) 1/4″ diameter [Ø6] oval, pan or round head fasteners of length and type to suit wall conditions (supplied by installer) through mounting holes in posts.

To mount on stud walls, provide concealed backing at screw points, secured to studs. Backing must comply with local building codes. If concealed backing is not provided, secure with toggle bolts.

To mount on solid walls, use plastic or fiber type plugs or expansion bolts.

For compliance with 2010 ADA Accessibility Standards, install unit so that centerline of bar is 48″ [1219] Above Finished Floor (AFF) if clear floor forward reach access is provided or 46″ [1168] AFF if side reach over obstruction is only provided.

• Product Care & Maintenance
• Technical Data Sheet – 0755-SS