Seat Cover Dispensers

• Dispenses 250 seat covers
• 20 gauge type 304 stainless steel construction
• Satin finish
• Surface mounted
• Curved front adds strength and elegance
• Concealed, multi-staked piano hinge
• Covers are self-feeding until supply is depleted
• Concealed bottom opening allows manual reloading

Model
20477-SM

Series
Roval™

Type
Surface Mounted Toilet Seat Cover Dispenser

Dimensions
15-3/4″ x 11″ x 2-3/8″ (400 x 280 x 60 mm)

Construction
20 gauge Type 304 Stainless Steel

Finish
Satin Finish

Mounting
Surface Mounted

Capacity
Dispenses 250 seat covers

Hinge
Concealed, Multi-Staked Piano Hinge

• Satin Finish

Covers are self-feeding until supply is depleted. Unit is manually reloaded with a full box through concealed opening in bottom on schedule determined by maintenance requirements.

Regularly inspect and replenish the supply of toilet seat covers according to facility maintenance requirements.

Clean stainless steel surfaces regularly with a soft clean rag moistened with a mild detergent, followed by a water-moistened clean rag and then a dry rag.

Mount unit on wall or partition surface using two (2) #10 x 1-1/4″ [32] self-threading flat head screws (by others).

Mounting holes are accessible through the dispenser slot during installation and are concealed behind the dispenser box after the dispensing product is loaded for vandal-resistant installation.

For compliance with 2010 ADA Accessibility Standards, install unit so that centerline of dispenser slot is 48″ [1219] maximum Above Finished Floor (AFF) if clear floor access is provided.

Where only side reach over an obstruction is provided, such as over a vanity, centerline of dispenser slot should be 46″ [1168] maximum AFF.

• Product Care & Maintenance
• Technical Data Sheet – 20477-SM